Configuring Netbios Name Filtering - 3Com PathBuilder S200 Series Owner's Manual

Bridge Filtering

Configuring NetBIOS Name Filtering

Introduction
How to Configure
NetBIOS Name
Filtering
Bridge Link
Parameters Record
78
This section describes how to use the Control Terminal Port (CTP) to configure
NetBIOS Name Filtering.
Follow these steps:
Step
1 Configure the NetBIOS Name Filter Action parameter in the Bridge Link
Parameters.
2 Configure the parameters in the NetBIOS Name Filter Table record.
Figure 40 highlights the parameter, NetBIOS Name Filter Action, in the Bridge Link
Parameters record.
Node: Address:
Menu: Configure Bridge
Bridge Parameters
Bridge Link Parameters
Entry Number
Hop Count Limit
Largest Frame Size
MAC Address Filter Action
Protocol Filter Action
NetBIOS Name Filter Action
STPE Link State
Figure 40. Bridge Link Parameters Record
Action
Date: Time:
Path
Bridging