Configuring Local Termination - 3Com PathBuilder S200 Series Owner's Manual

LLC2 Local Termination

Configuring Local Termination

Configuring for
Local Termination
Before You Begin
Configuring the
Bridge
106
Perform the following procedures to configure Local Termination on a Bridge node.
Step
1 Configure the node.
2 Configure the ports.
3 Configure the route selection table.
4 Configure the LAN connection table.
5 Configure the Mnemonic Table and PVC Setup table.
6 Configure the bridge for Local Termination.
Go to ""Configuring the Bridge" section on page 106", for details on
configuring the bridge table for Local Termination.
Connect to the node using Control Terminal Port (CTP) access.
Obtain the following information:
• MAC Address of the device being spoofed.
• SAP value of the device being spoofed.
Follow these steps to configure bridge parameters to enable Local Termination on a
node.
Step
Select Configure -> Configure
1
Bridge from the Main menu.
Note
Bridge must be configured for
source routing.
(*Bridge Type=SR).
Action
Action
The Configure Bridge Record
menu appears.
Result
Bridging