Configuring The Protocol Filter Table - 3Com PathBuilder S200 Series Owner's Manual

Configuring the Protocol Filter Table

Introduction
The Protocol Filter Table prevents stations operating with a certain protocol from
operating outside their intended scope. This filtering action is applied to that part of
the frame that defines the protocol carried by the frame.
Protocol Filter
Figure 36 shows the Protocol Filter Table parameters.
Table Parameters
Figure 36. Configure Protocol Filter Table Menu
Parameters These parameters make up the Protocol Filter Table Record.
Entry Number
Bridging
T0008-16F
Note
A Table boot must be performed to implement changes to the Protocol Filter
Table parameters.
Node: Address:
Menu: Configure Bridge
Bridge Parameters
Bridge Link Parameters
MAC Address Filter Table
Protocol Filter Table
Entry Number
Protocol Type
Protocol Value
Incoming Protocol Link Action
Outgoing Protocol Link Action
Range: 1 to 100
Default: 1
Description: Entry number used to reference this table record.
Bridge Filtering
Date: Time:
Path:
71
Release 5.2M