LIFESTYLER Expance 2000 Owner's Manual page 6

DIAGRAM OF THE CONSOLE
The heart of the treadmill is the state-of-the-art programmable console. The console offers both manual and pro-
gram operation, and features an array of independent LED displays to give you continuous exercise feedback.
Please read these instructions carefully before operating the console.
CONSOLE DIAGRAM
Current Segment q .
_DO0000"
s_e, M ea" 'n_ i2 -15. DO0000
_t0 -10. DO0000
zl -7,. DO0000
zl -70. DO0000
z4
-is.
DO0000
z2 -10- DO0000
m'_SS L_We, Z0 -is, DO0000
C[[[[_ I., -_o. DO0000
16 -,4. DO0000
C_ I,= -+to, DO0000
t.2 -_4, DO0000
_o -_o, D O000,Q,
(=_) o o
RUH
"Ce
trice Indicator (See pages 11 and 12)
Pulse Earclip Jack ---_' 1 o _ Safety Key/Clip
6
TURNING ON THE POWER
If the safety key is in the console, remove it. Plug in the power cord (see PLUGGING IN THE POWER CORD on
page 5).
Stand on the frame rails of the treadmill. Find the clip attached by a cord to the safety key, and slide the clip onto
the waistband of your clothing.
Ji WAR NING:
Do not stand on the walking belt while turning on the power. Always wear the
clip when operating the treadmill. If you fall, the safety key will be pulled from the console, instantly turn-
ing off the power.
Insert the safety key into the console. The six LED displays on the right side of the console will light. Note: If the
safety key was in the console when the power cord was plugged in, a "PO" will appear in the speed display. If
this occurs, remove the safety key, wait for five seconds and then reinsert it.
MANUALOPERATION
When the power is turned on, the console will be in the manual mode and the walking belt will be stationary. The
speed of the walking belt can be controlled by pressing the SPEED buttons. Each time the SPEED increase but-
ton is pressed, the speed will increase by 0.1 mite per hour, beginning at 0.5 miles per hour. Each time the
SPEED decrease button is pressed, the speed will decrease by 0.1 mile per hour. The SPEED buttons can be
held down to change the speed rapidly. The speed can be set at a minimum of 0.5 miles per hour, up to a maxi-
mum of 10 miles per hour.
kWARNIN G:
After the SPEED buttons are pressed, it will take a few seconds for the
walking belt to reach the selected speed. Adjust the speed gradually until you are familiar with
the operation of the treadmill.