LIFESTYLER Expance 2000 Owner's Manual page 4

ASSEMBLY
Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials
until assembly is completed. TOOLS REQUIREO FOR ASSEMBLY: An 8" adjustable wrench
(not included).
°
Carefully raise the right Upright (3) to a vertical position. Align
the hole in the lower end of the Upright with the hole in the side
of the Right Frame Rail (47). Insert a 3/4" x 4 1/2 " Bolt (2),
with a Washer (1), into the Upright and thread the Bolt into the
Right Frame Rail. Do not fully tighten the Bolt yet. Repeat the
step with the left Upright (not shown).
2
47 2
o
It is recommended that a second person hold the Handrail (5)
while you complete step 2.
Connect the Handrail Wire Harness (13) to the Upright Wire
Harness (30). Slide the brackets on the Handrail (5) into the
right Upright (3) and the left Upright (not shown). Be careful not
to damage the wires. Insert a 3/8" x 1 1/4" Bolt (7), with a
Washer (1), into each Upright. It may be necessary to raise the
front of the Handrail to insert the Bolts. Tighten the Bolts.
Tighten the 3/4" x 4 1/2" Bolts (2) in the lower ends of the
Uprights (see step 1).
7
,
Slide the metal Clothes Clip onto the Pulse Earclip in the indicat-
ed location. The use of the Pulse Earclip is explained in OPER-
ATING THE MONITOR MODES on page 9.
3
Pulse Earclip
Clothes Clip
4. Remove the paper backing from the Wrench Clip (84). Press the
Wrench Clip onto the Right Endcap (78) in the indicated loca-
tion. Press the Allen Wrench (83) into the Wrench Clip.
78
Make sure that all parts are tightened before using the treadmill.
_