LIFESTYLER Expance 2000 Owner's Manual page 11

C.
If the walking belt is overtightened, treadmill performance may
decrease and the walking belt may be permanently damaged.
Remove the safety key and UNPLUG THE POWER CORD.
Using the allen wrench, turn both rear roller adjustment bolts
counterclockwise, 1/4 of a turn. When the walking belt is prop-
erly tightened, you should be able to lift each side of the walking
belt 3-4 inches off the walking platform. The center of the walk-
ing belt should just touch the walking platform. Be careful to
keep the walking belt centered. Plug in the power cord, insert
the safety key and run the treadmill for a few minutes. Repeat
until the walking belt is properly tightened.
Rear Roller
Adjustment Bolts
5. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a.
If the walking belt has shifted to the left, first remove the safety
key and UNPLUG THE POWER CORD. Using the allen
wrench, turn the left rear roller adjustment bolt clockwise, and
the right bolt counterclockwise, 1/4 of a turn each. Be careful
not to overtighten the walking belt. Plug in the power cord,
insert the safety key and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
b.
o
a.
If the walking belt has shifted to the right, first remove the safe-
ty key and UNPLUG THE POWER CORD. Using the allen
wrench, turn the left rear roller adjustment bolt counterclock-
wise, and the right bolt clockwise, 1/4 of a turn each. Be care-
ful not to overtighten the walking belt. Plug in the power cord,
insert the safety key and run the treadmill for a few minutes.
Repeat until the walking belt is centered.
If the walking belt slips when walked on, first remove the safety
key and UNPLUG THE POWER CORD. Using the allen
wrench, turn both rear roller adjustment bolts clockwise, 1/4 of a
turn. When the walking belt is correctly tightened, you should be
able to lift each side of the walking belt 3-4 inches off the walk-
ing platform. The center of the walking belt should just touch
the walking platform. Be careful to keep the walking belt cen-
tered. Plug in the power cord, insert the safety key and run the
treadmill for a few minutes. Repeat until the walking belt is prop-
erly tightened.
SYMPTOM: THE SERVICE INDICATOR ON THE CONSOLE LIGHTS
b°
The service indicator on the console is designed to alert you when routine maintenance is needed. After
the treadmill has been operated for 10 miles, the service indicator wilt light. When the service indicator
lights, the bolts attaching the console and the handrails should be tightened. In addition, the tension of the
walking belt should be checked (see 4. c. above). To extinguish the service indicator, first hold down the
STOP bar while inserting the safety key into the console. A service code ("$1 ") will appear in the INCLINE
display. To reset the service code and extinguish the service indicator, hold down the STOP bar while
removing the safety key.
After the treadmill has been operated for 600 miles, the service indicator will again light. When the service
indicator lights, the tension of the walking belt should be checked (see 4. c. above). In addition, a service
technician should check the amp draw and the motor brushes. For service, see the back cover of the own-
er's manual. To extinguish the service indicator, first hold down the STOP bar while inserting the safety
key into the console. A service code ("$3") will appear in the INCLINE display. To reset the service code
and extinguish the service indicator, hold down the STOP bar while removing the safety key.
11