Assembly - LIFESTYLER 831.297052 Owner's Manual

ASSEMBLY
Set the treadmill in a cleared area and remove all packing materials.
included before disposing of the packing materials.
TOOLS NEEDED FOR ASSEMBLY: adjustable wrench
,
Align the lower end of the Right Handrail (20) with the
holes in the side of the treadmill Frame (47). Attach the
Handrail with two Short Handrail Bolts (35) and Handrail
Washers (36). Be careful not to pinch the wires in
the Handrail. Do not fully tighten the Bolts. Attach the
Left Handrail (not shown) in the same manner.
.
Place the Console (8) on the upper end of the Left and
Right Handrails (1,20) as shown. Attach the Console
with two Long Handrail Bolts (2). Be careful not to
pinch the wires in the Handrail. Do not fully tighten
the Bolts.
.
Plug the Handrail Wire Harness (62), located in the
Right Handrail (20), into the connector on the underside
of the Console (8). The small latch on the Harness
should snap onto the connector. If the Harness does
not fit easily, turn it; do not force the Harness into the
connector.
4,
Plug the lower end of the Handrail Wire Harness (62)
into the connector on the right side of the Belly Pan (38).
The small latch on the Harness should snap onto the
connector. If the Harness does not fit easily, turn it; do
not force the Harness into the connector.
Firmly tighten the Bolts on the lower and upper ends of
both Handrails (not shown). Make sure that all parts are
tightened securely before using the treadmill.
Be sure that all parts are
20
47 36 35
8
38
62
6