Assembly - LIFESTYLER 5.0 MPH Owner's Manual

ASSEMBLY
Set the treadmill in a cleared area and remove all packing materials.
Included before disposing of the packing materials.
1. (5.0 MPH and 6.0 MPH)
Raise the Upright Post to the vertical position. Insert the
Lock Knob, with the Lock Knob Washer, into the Upright
Post. Turn the Lock Knob clockwise until it is almost tight.
Leave a little play in the Upright Post for steps 2 and 3.
.
(8.0 MPH and 10.0 MPH)
Insert the Lock Knob, with the Lock Knob Washer, into the
Upright Post. Place the Upright Spacer on the end of the
Lock Knob. Hold the Upright Spacer in place and raise
the Upright Post to the vertical position. Be careful not to
pinch your fingers. Turn the Lock Knob clockwise until it
is almost tight. Leave a little play in the Upright Post for
the following steps.
.
(All models)
Align the upper end of the Side Rail with the left end of
the Handrail. Turn the Handrail in the direction shown to
thread the Handrail into the Side Rail. (Note: If the
Handrail will not turn easily, loosen the Handrail Bolt
slightly.) Tighten the Handrail and the Handrail Bolt.
.
(All models)
Align the lower end of the Side Rail with the hole in the
side of the treadmill Frame. Insert the Side Rail Bolt
through the Side Rail and Frame. Reach under the
Frame and tighten the Side Rail Nut onto the end of the
Side Rail Bolt. Tighten the Lock Knob (see step 1).
Make sure that all parts are tightened securely before
using the treadmill.
Be sure that all parts are
ht Post
,,_r_ Lock Knob
Knob Washer
Upright Post Lock Knob
Lock Knob
Washer
Side Rail
Handrail
Handrail Bolt
Side Rail
Side Rail Bolt I.o_"
/
Frame
Side Rail Nut
5