Advertisement
ASSEMBLY
CAUTION: Carefully read and follow step I below before removing the restralnlng tie (see drawing 1
below). If the restraining tie Is removed prematurely,
serious bodily injury may result. Assembly requires
two people. Set the treadmill in a cleared area and remove the packing materials, except for the restraining tie.
Do not dispose of the packing materials until assembly is completed. Assembly requires the Included allen
wrench
I , two adjustable wrenches _
, a phillips screwdriver .-===--={_)
(not Included).
°
Slide the Left Upright (1) onto the left side of the Base
(59). It may be necessary to firmly push down on the
Left Upright until it Is fully seated on the Base.
Remove the restraining tie from the Base.
Attach the left handrail to the Base (59) with a Handrail
Bolt (93), Handrail Washer (67), and Handrail Nut (4). Do
not tighten the Handrail Bolt yet. Using the allen
wrench, tighten two of the four Upright Screws (63) into
the Left Upright (1) and the Base.
59
Restraining
2. Slide the Right Upright (44) onto the right side of the Base
(59). It may be necessary to firmly push down on the
Right Upright until it is fully seated on the Base. Be
careful not to pinch the Wire Harness (25) between
the Right Upright and the Base.
Attach the right handrail to the Base (59) with a Handrail
Bolt (93), Handrail Washer (67), and Handrail Nut (4). Do
not tighten the Handrail Bolt yet. Using the allen
wrench, tighten two Upright Screws (63) into the Right
Upright (44) and the Base.
Hand tighten the Handrail Nuts (4) used in steps 1 and 2.
Using a wrench, tighten the Handrail Bolts (93) used in
steps 1 and 2.
Remove the wire ties (not shown) attaching the Console
(9) to the Right Upright (44).
48
3. Set the Console Base (9) on the Left and Right Uprights
(1,44).
While one person carefully feeds any slack Wire Harness
(25) down into the Right Upright (44), a second person
should carefully pull the slack Wire Harness from the
lower end of the Right Upright. Refer to drawing 2 above.
Feed the slack Wire Harness into the Belly Pan (48).
Attach the Console Base (9) with four Screws (75).
9
75
5
Advertisement
