LIFESTYLER 831.297052 Owner's Manual page 12

C.
If the walking belt is overtightened, treadmill performance
may be reduced and the walking belt permanently
damaged. Remove the safety key and UNPLUG THE
POWER CORD. With the allen wrench included, turn
both rear roller adjustment bolts counterclockwise, 1/4 of
a turn. Plug in the power cord and reinsert the safety
key. Run the treadmill for a couple of minutes. Repeat
until the tension of the walking belt is correct. When the
tension is correct, you should be able to lift each side of
the walking belt 3-4 inches off the walking platform. The
center of the walking belt should just touch the surface of
the walking platform. Be careful to keep the walking belt
centered on the walking platform.
Rear Roller
Adjustment Bolts
6. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON
a.
b,
c.
If the walking belt has shifted to the left, first remove the
safety key from the console and UNPLUG THE POWER
CORD. With the allen wrench included, turn the left rear
roller adjustment bolt clockwise, and the right bolt coun-
terclockwise, 1/4 of a turn each. Plug in the power cord
and reinsert the safety key. Run the treadmill for a cou-
ple of minutes. Repeat as necessary until the walking
belt is centered.
If the walking belt has shifted to the right, first remove the
safety key from the console and UNPLUG THE POWER
CORD. With the allen wrench included, turn the left rear
roller adjustment bolt counterclockwise, and the right bolt
clockwise, 1/4 of a turn each. Plug in the power cord
and reinsert the safety key. Run the treadmill for a cou-
ple of minutes. Repeat as necessary until the walking
belt is centered.
If the walking belt slips when walked on, first remove the
safety key from the console and UNPLUG THE POWER
CORD. With the allen wrench included, turn both rear
roller adjustment bolts clockwise, 1/4 of a turn. Plug in
the power cord and reinsert the safety key. Run the
treadmill for a couple of minutes. Repeat as necessary
until the tension of the walking belt is correct. When the
a.
b.
c.
tension is correct, you should be able to lift each side of the walking belt 3-4 inches off the walk-
ing platform. The center of the walking belt should remain just at the surface of the walking plat-
form. Be careful to keep the walking belt centered on the walking platform.
STORAGE
12
Unplug the power cord when the treadmill is not in use. Remove
the bolts and washers from the lower end of the handrails. Keep
the bolts and washers in a secure location. Carefully lay the
handrails and console on the treadmill. Be careful not to pinch
the wires in the handrail. The allen wrench can be stored con-
veniently by removing the backing from the wrench clip and
pressing it onto one of the endcaps.
Endcap
!S_-'___---'- Wrench Clip