Table of Contents
Advertisement
About page numbering
When you, or a user, create a Bates format, you specify the starting page number. By default, each
document that is scanned using that format uses the same starting page number. However, users
can control the page numbering by performing the following tasks:
Manually specifying the starting page number when they select a Bates format at the scanning
■
device.
Using a Checkpoint. When users want to number a collection of separate documents
■
sequentially, they can create a Checkpoint identifier. They must create the Checkpoint when
they scan the first document. When they select the Checkpoint on subsequent scans, the page
numbering continues from where it left off. For example, if a user scans two 10-page
documents using the same Checkpoint, the first document will be numbered 1 through 10 and
the second document will be numbered 11 through 20.
Using the options available on the Document Sent Successfully screen. Pressing
■
next job to use the starting page number specified in the Bates format. Pressing
(and then scanning in a new page) continues numbering from the point where the
Document
previous job left off. Pressing
using the same page numbering as the original scan.
To enable the Bates Numbering service:
1
In the console tree, click
tab.
Select the
2
Enables Bates
the connector's Advanced tab.)
New Destination
System Information > Properties
check box. (You enable Bates Numbering for a specific connector on
eCopy ShareScan OP Configuration Guide | 37
sends the document to the target destination
and then click the
Done
sets the
New
Bates Numbering
Advertisement
Table of Contents
