Removing Add-On Connectors; Configuring Connectors - Sharp eCopy ShareScan OP Configuration Manual

Removing add-on connectors

You can remove an add-on connector from the Connectors node in the console tree only when the
Remove icon appears next to the connector name, indicating that the connector has been
uninstalled or is otherwise unavailable.
To remove an add-on connector:
1 Run the connector's setup program and then select the Uninstall option.
In the console tree, right-click the connector's name and then click
2

Configuring connectors

You configure connectors by specifying various settings, such as the appearance of the connector's
button and the desired image format. You save the settings in a connector profile. After creating and
saving a profile, you can enable it for use with a particular device. You can also publish connector
profiles to all eCopy-enabled devices on the network.
For information about configuring individual connectors, refer to the appropriate section in this
document or in the Help.
Understanding connector profiles
You can define multiple profiles for each connector. Each profile defines a set of configuration
options for that connector. Using connector profiles enables you to apply different connector
settings to different devices.
The following table illustrates how you could use two different connector profiles. You could assign
"Profile1" to a device located in the Sales department and "Profile2" to a device in the Human
Resources department.
Target folder
Job type
Default e-mail
Searchable text
When you install the connectors, a default profile is included for each connector. Before you can
enable a connector for use with a device, you must configure at least one profile for it.
Profile1
\\sales\resumes
Full-time, Part-time
sales@ecopy.com
No
eCopy ShareScan OP Configuration Guide | 11
Delete
Profile2
\\hr\resumes
Full-time, Contract
hr@ecopy.com
Yes
.