Table of Contents
Advertisement
(6) MULTICAST:
If the DVR is connected to a server system, which provide Multicast mode, settings for
this mode can be done here.
(7) HTTP PORT:
Default setting for this port is: 80. The port can be changed if necessary.
(8) CONTROL PORT:
Default setting for this port is: 1600. The port can be changed if necessary.
(9) DATA PORT:
Default setting for this port is: 37260. The port can be changed if necessary.
ATTENTION: If several users simultaneously access the DVR via network, each user
requires a DATA PORT (max. 4 users). Upon activating ports, e.g. in firewalls, the
following ports have to be opened additionally:
DATA PORT +1
DATA PORT +2
DATA PORT +3
Example: Dataport 37260 > ports to be opened : 37260, 37261, 37262, 37263
(10) BW control:
Network bandwidth control, setting of maximum network bandwidth usage in the range 0
~ 8192 KB/s.
(11) MAC ADDR:
Display of network interface MAC address (cannot be changed).
3.7.2 ALARM (Network alarm)
NETWORK SETUP MENU
CONFIG
PROTOCOL
ALARM
PORT NUMBER
EMAIL
UNIQUE ID
PASSWORD
PPPoE
SERVER1
DDNS
SERVER2
SERVER3
Having installed the optionally available PowerCon software, the DVR can transmit a
network alarm to up to 3 recipiants in case of event.
YES:
NO:
IP - ADRESS:
PORT:
UDP
01600
_ _ _ _ _ _ _ _ _
192.168.001.122
192.168.001.123
192.168.001.124
- 38 -
Multicast mode ON
Multicast mode OFF
IP-adress of Multicast server
Port of Multicast - server
EDR910_1610_ma_en_rev1 00
Advertisement
Table of Contents
