Table of Contents
Advertisement
3.6 VIDEO LOSS MENU
VLOSS SETUP MENU
CAMERA 1
VLOSS
CAMERA 2
CAMERA 3
DURATION
CAMERA 4
ALARM OUTPUT
CAMERA 5
ALARM EMAIL
CAMERA 6
BUZZER
CAMERA 7
ALARM NETWORK NO
CAMERA 8
CAMERA 9
SUMMARY
Menu display for EDR-910, EDR1610 identical, but with 16 cameras.
Define the reaction upon video signal loss for each camera in this menu:
(1) VLOSS:
(2) DURATION:
Alarm duration. Duration applies to buzzer and output contact and is adjustable from
1~99 seconds.
(3) ALARM OUTPUT: Output relay activation.
(4) ALARM EMAIL:
By selecting "ON", an email is sent in case of alarm, containing the alarm message and
the DVR IP address as sender. Define the email recipiant's details in the NETWORK
menu.
(5) BUZZER: Alarm buzzer activation
(6) ALARM NETWORK:
Network alarm function activation. Network alarm reception requires installation of the
optionally available PowerCon software. The network alarm transmits both the alarm
message and the DVR IP address as sender to up to 3 recipiants.
(10) SUMMARY:
The SUMMARY menu item gives a summary on the settings for control purpose. Use the
JOG to browse the individual settings.
ATTENTION: This menu does not allow any editing of settings.
ENABLE
05 SEC
01
NO
DISABLE
ENABLE:
DISABLE:
1:
NONE:
ENABLE:
DISABLE:
YES:
NO:
- 36 -
Video loss detection is activated.
Video loss detection is deactivated.
Output relay 1 ~ 4 (selection) is switched in
case of alarm
Output relay is deactivated.
Alarm buzzer is activated.
Alarm buzzer is deactivated.
Network alarm is activated.
Network alarm is deactivated.
EDR910_1610_ma_en_rev1 00
Advertisement
Table of Contents
