S2-6 Through S2-8: Line Type (Models 3088/K And 3088/T); Console; S2-6 Through S2-8 Line Type Settings - Patton electronics RocketLink-G 3088 Series User Manual

Model 3088 Series User Manual
S2-4 S2-5
OFF OFF

S2-6 through S2-8: Line Type (Models 3088/K and 3088/T)

The RocketLink-G has two different line types, T1 and E1. T1 has three different settings, and E1 has five dif-
ferent settings.
S2-6
ON
OFF
ON
OFF
ON
OFF
ON
OFF
a. For T1 operation, pass framing must be enabled (see Pass Framing param-
eter in

Console

The 3088 offers a console command line interface. To access the console, use a VT100 emulator configured to
19,200 kbps, 1 stop bit, no parity, and XON-XOFF flow control. Log into the unit using the default pass-
word. No username will be needed.
Note For software release 2.1.2, log in with the default password
For software release 2.1.3, log in with the default password
Through the console, the following variables can be configured:
• Password: The password used to login to the console.
• Circuit ID: The circuit ID communicated to other units via EOC. EOC (Embedded Operations Channel)
is an out-of-band channel specified in the G.991.2 standard for SHDSL. We use standard EOC messages
for our remote loopback. The 3088 also supports proprietary EOC messages that allow a 3096RC to con-
figure it.
• Clock Mode: The following options are available:
- Internal: The internal oscillator in the 3088 provides the clock to both the serial/T1/E1 and
DSL interfaces.
- Network: The T1/E1 interface provides the clock for the DSL interface (T1/E1 only).
Introduction
Table 18. S2-4 and S2-5 Clock Mode Settings
Clock Mode
Reserved
Table 19. S2-6 through S2-8 Line Type Settings
S2-7 S2-8 Line Type
ON ON
T1-Unframed
ON ON
T1-SuperFrame
OFF ON
T1-ExtendedSuperFrame
OFF ON E1-Unframed (G.703 Clear Channel)
ON OFF E1-Structured (G.704)
ON OFF E1-CRC
OFF OFF E1-Multiframe
OFF OFF E1-CRC Multiframe
table 2
on page 20 for details).
Description
a
a
a
2 • Configuration
.
.
32