Introduction; Software (Cli) Configuration; Hardware (Dip-Switch) Configuration; Rocketlink-G (Model 3088/D Shown) - Patton electronics RocketLink-G 3088 Series User Manual

Model 3088 Series User Manual

Introduction

You can configure the RocketLink-G (see
• Software configuration using command line interface (CLI) via the console port
• Hardware configuration via DIP switches

Software (CLI) configuration

To use software configuration you must set all the DIP switches to the ON position before powering-up the
RocketLink-G. When all the DIP switches are set to ON the RocketLink-G will operate in software-configura-
tion mode. When set for software-configuration mode the RocketLink-G will read any configuration data pre-
viously saved to FLASH memory during system power-up. If no configuration data was previously saved to
FLASH, then the RocketLink-G will load the factory-default configuration from FLASH memory. After
power-up, you may use console commands or the Embedded Operations Channel (EOC) to modify the con-
figuration parameters.

Hardware (DIP-switch) configuration

To use DIP-switch configuration you must first set the DIP switches to a position other than all OFF or all ON
before powering-up the RocketLink-G. When all the DIP switches are set to any position other than all OFF or
all ON the RocketLink-G will operate in hardware (DIP-switch)-configuration mode. In DIP-switch-configu-
ration mode the RocketLink-G will read the DIP-switch settings during system startup and configure itself
according to the switch settings.
Once you power-up the RocketLink-G in DIP-switch mode it will operate in DIP-switch mode until powered-
down. When operating in DIP-switch mode you cannot change any configuration settings:
• Changing the DIP switch settings while the device is running will not modify the operating configuration
because the RocketLink-G only reads the DIP switches during system startup.
• If you attempt to modify the configuration by issuing console commands, the device will not execute your
commands. Instead, the RocketLink-G will respond with a message indicating the device is operating in
DIP-switch-configuration mode.

Introduction

figure 3) in one of two ways:
Figure 3. RocketLink-G (Model 3088/D shown)
2 • Configuration
19