Opening The Case; Connecting The Model 3088/D To X.21 Dte Or Dce; Opening The 3088 Case With A Small Screwdriver - Patton electronics RocketLink-G 3088 Series User Manual

Model 3088 Series User Manual
such as a modem or multiplexer. When connecting the X.21 interface of the Model 3088/D to your DTE or
DCE device, use an X.21 straight-through cable (See
Remote Model 3088
Figure 10. Connecting the Model 3088/D to X.21 DTE or DCE
To change the DCE/DTE orientation from the default position (DCE), you must open the case Model
3088/D case.

Opening the Case

To open the Model 3088/D case, insert a flat head screw driver into an open slot on both sides of the case, as
in figure 11. Twist the screw driver head slightly and the top half of the case will separate from the lower half,
as in figure 11. Be careful not to damage the PC-board mounted components.
Installation
U
N T
- G
™
i n k
e t L
o le
c k n s
R o C o
Model 3088/D (DCE or DTE)
Figure 11. Opening the 3088 case with a small screwdriver
figure 10).
DSL Span
Straight-Through 15-pin
D-Sub Cable
U
N T
- G
™
i n k
e t L
o l e
c k
n s
R o
C o
3 • RocketLink-G installation
Router (DTE)
OR
Mux (DCE)
45