Initial Configuration Through The Rs-232 Control Port; Connecting The Db9-Rj45 Adapter With The Included Cable; Setting Up The Hyperterminal (Or Similar Program) Session - Patton electronics 3092 Getting Started Manual

Model 3092 iDSL DACS Getting Started Guide
- Line Type: either E1 or E1-CRC
- Line Coding: either HDB3 or AMI
Initial Configuration through the RS-232 Control Port
Initially you must configure the 3092's IP address and—in rare instances—change the netmask from the
default settings.
Note

Connecting the DB9-RJ45 adapter with the included cable

Do the following:
1. Connect the DB9-RJ45 adapter to your PC's RS-232 serial port
2. Connect the RJ45-RJ45 cable between the adapter you installed in step 1 and the RS-232 Config port on
the rear of the Model 3092.

Setting up the HyperTerminal (or similar program) session

Do the following:
1. Open a HyperTerminal session by double-clicking on HYPERTRM.EXE.
2. Type a connection name (for example, 3092 Config), select an icon, then click

Initial Configuration through the RS-232 Control Port

Do not connect power or the Ethernet connection to the Model 3092
at this time.
Figure 13. Connection Description window
3 • Configuring the DACS for operation
OK (see
figure 13 .
)
33