Dsl Status Command; Dsl Clear Errcntrs Command; T1/E1 Configuration Commands - Patton electronics RocketLink-G 3088 Series User Manual

Model 3088 Series User Manual
• DSL Error Monitor
Startup Delay
?startdelay⇒
The DSL error monitor inspects intervals to see if they have met the error threshold (maxint). If the error mon-
itor finds a certain number (intcnt) of intervals that meet or exceed the error threshold, it will restart the DSL
link. The error monitor will wait (startdelay) seconds after the DSL link comes up before it begins monitoring
errors. After the startup delay, it will check the number of errors that have occurred during each (inttime) sec-
onds to see if they meet the error threshold. The error monitor inspects (totint) intervals before it stops.
Note
Setting maxint to 0 disables the error monitor and setting totint to 0 causes
the error monitor to run continuously.
The following commands configure the error monitor:
• dsl set errmon maxint <maxint>: Sets the number of errors allowed in an interval causes it to be consid-
ered an errored interval. If this is set to '0', then the error monitor is disabled.
• dsl set errmon inttime <inttime>: Sets the length of each interval.
• dsl set errmon intcnt <intcnt>: Sets the number of errored intervals that causes the DSL link to restart.
• dsl set errmon totint <totint>: Sets the number of intervals to inspect for errors before disabling the error
monitor. If this is set to '0', then the error monitor will run continuously.
• dsl set errmon startdelay <startdelay>: Sets the number of seconds to wait after the DSL link comes up
before the error monitor starts inspecting intervals.
Changing the data rate (dsl set timeslots), the clock mode (system set clockmode), the Annex (dsl set
annex), or Line Probe (dsl set lineprobe), or the DSL error monitor settings will not take effect on the DSL
link until the link restarts. The dsl start command restarts the DSL link.

DSL Status Command

The dsl show status command shows the following DSL status information: link state, sync state, link speed,
error counters, line condition, noise margin, and test mode status.

DSL Clear Errcntrs Command

The dsl clear errcntrs command clears the error counters.

T1/E1 Configuration Commands

t1e1 set linetype <t1-unframed|t1-sf|t1-esf|e1-unframed|e1-fractional|e1-crc|e1-mf|e1-crcmf>
Select the T1 or E1 framing format to use.
t1e1 set linecode <ami|hdb3|b8zs>
Select the line code to use. HDB3 can only be used for E1 line types, and B8ZS can only be used for T1
line types.
Introduction
Interval 1 Interval 2
?inttime⇒ ?inttime⇒
... Interval totint
?inttime⇒ ?inttime⇒
2 • Configuration
37