RocketLink-G™ Model 3088 Series G.SHDSL NTU with Fixed Serial Interfaces Quick Start Guide Important —This is a Class A device and is intended for use in a light industrial environment. It is not intended nor approved for use in an industrial or residential environment. Document Number: 03325U7-001 Rev.
• This device contains no user serviceable parts. The equipment shall be returned to Patton Electronics for repairs, or repaired by qualified service personnel. WARNING • AC Powered Units: The external power adaptor shall be a listed Limited Power Source. Ensure that the power cable used meets all applicable standards for the country in which it is to be installed, and that it is connected to a wall outlet which has earth ground.
2.0 Power up the NTU Your G.SHDSL NTU comes with one of the following power supply options: External AC adaptor with detachable power cord • External DC power supply with terminal block connector (model 48V-PSM3) • 2.1 Models with external AC adaptor Connect female plug of the AC power cord to the AC adaptor provided.
Console TM / ERR Terminal Power Model 3088/CA front panel Figure 2. 2.3 Power up indication Verify that the Power LED (see figure 2) illuminates and remains lit. 3.0 Connect the G.SHDSL port Obtain single-twisted-pair cable with an RJ-45 plug connector at each end. Plug one end of the cable into the RJ-45 socket (labelled DSL) on the RocketLink-G NTU.
Connect the serial cable to the RocketLink-G serial port as follows: Attach the male connector of the serial cable to the female serial connector on the RocketLink-G. Attach the other end of the cable to the serial connector on the local serial NTU. The V.35 interface is wired as a DCE.
TBR12 & 13 (K and T models) • AS/ACIF S016:2001 (K and T models) • AS/ACIF S043:2003 • -1979, expires 21.04.2011(3088/T/EUI) • -1980, expires 21.04.2011(3088/K/EUI) • -1981, expires 21.04.2011(3088/D/EUI) • -1982, expires 21.04.2011(3088/CA/EUI) • A.2 FCC Part 68 (ACTA) Statement This equipment complies with Part 68 of FCC rules and the requirements adopted by ACTA.
(See section for German version.) A.6 “EG-Konformitätserklärung” RocketLink-G 3088 Series Product Description: This equipment conforms to the requirements of Council Directive 1999/5/EC on the approximation of the laws of the member states relating to Radio and Telecommunication Terminal Equipment and the mutual recognition of their conformity.
Die Sicherheitshinweise in der mitgelieferten Produktdokumentation sind zu beachten. Die Konformität mit der oben erwähnten Richtlinie wird durch das CE-Zeichen auf dem Gerät bestätigt. Die unterzeichnete Konformitätserklärung kann heruntergeladen werden von: www.patton.com/ certifications/. A.7 Authorized European Representative D R M Green European Compliance Services Limited.