Connecting The Model 3088/K Serial Interface; Connecting The Model 3088/K To An E1 Network; Setting The Dce/Dte Strap (X.21 Only) - Patton electronics RocketLink-G 3088 Series User Manual

Model 3088 Series User Manual
The DCE/DTE strap is located on the top side of the 3088/D pc board (See
of the strap indicate the configuration of the X.21 port (for example, if the DCE arrows are pointing toward
the DB-15 connector, the X.21 port is wired as a DCE). Change the DCE/DTE orientation by pulling the
strap out of its socket, rotating it 180°, then plugging the strap back into the socket. You will see that the
DCE/DTE arrows now point in the opposite directions, showing the new configuration of the X.21 port. To
close the case, fit the two halves together snugly and snap them back in place.

Connecting the Model 3088/K serial interface

CAUTION

Connecting the Model 3088/K to an E1 Network

The Model 3088/K supports E1 network connections. This section describes how to connect the network to
your Model 3088/K.
Installation
DB-15 Connector
Figure 12. Setting the DCE/DTE Strap (X.21 only)
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
3 • RocketLink-G installation
figure
DCE/DTE Strap
12). The arrows on the top
46