Patton electronics SMARTNODE 4110 Series User Manual page 37

SmartNode 4520 & 4110 Series User Manual
CAUTION
3. Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to "Contacting Patton for assistance"
power cord.
4. Connect the male end of the power cord to an appropriate power outlet.
Figure 23. Router front panel LEDs and Console port locations (SmartNode 4524 shown)
5. Verify that the green Power LED is lit (see
Congratulations, you have finished installing the SmartNode Gateway Router! Now go to chapter 4,
started with the SmartNode"
Installing the gateway router
The router power supply automatically adjusts to accept an input
voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
on page 51 to find out how to replace it with a compatible
figure
on page 38.
23).
3 • Hardware installation
"Getting
37