▼ To Verify Attached Storage (Solaris OS)
1. Use the cfgadm -al command to verify attached storage.
%
cfgadm -al
Ap_Id
c3
c3::200600a0b816005e
c3::200700a0b816005e
c4
pcie5
If the HBA is properly installed and storage is connected properly, you will see
output similar to that shown in the example. In this example, one port of an HBA
adapter is connected through a fabric switch to two ports of a disk array.
2. If an adapter is shown as unconfigured, use the cfgadm -c configure
command to configure it.
14
Sun StorageTek ATCA 4Gb FC Dual Port HBA Installation Guide • April 2010
Type
Receptacle
fc-fabric
connected
disk
connected
disk
connected
fc
connected
fibre/hp
connected
Occupant
Condition
configured
unknown
configured
unknown
configured
unknown
unconfigured unknown
configured
ok