To Install Battery Pack - Craftsman 973.113470 Operator's Manual

_lb WARNING: Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
SWITCH
Gee Figure 2.
To turn your drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
SWITCH
TRIGGER Fig. 2
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed and torque with increased trigger pressure, Speed is
controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from the
switch during use. Do not be concerned, this is a normal
part of the switch function.
TO INSTALL BATTERY PACK
• Lock switch trigger on your drill by placing the direction
of rotation selector in center position. See Figure 4.
• Place battery pack in your drill. Align raised rib on
battery pack with groove inside drill. See Figure 3.
BATrERY
PACK
DEPRESSLATCHES TO
RELEASEBA"I-I'ERY PACK
LATCHES
Fig, 3
• Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in drill
before beginning operation.
CAUTION: When placing battery pack in your drill,
be sure raised rib on battery pack aligns with groove
inside drill and latches snap into place properly.
Improper assembly of battery pack can cause
damage to internal components,
TO REMOVE BA'I-FERY PACK
• Lock switch trigger on your drill by placing the direction
of rotation selector in center position. See
Figure
4.
• Locate latches on end of battery pack and depress to
release battery pack from your drill. See F/g/Jre 3.
• Remove battery pack from your drill.
9