GE P2S975 Owner's Manual page 35

Possible Causes What To Do
Clock and timer do Plug on range is not completely . Make sure electrical plug is plugged into a live, properly
not work inserted in the electrical outlet, grounded outlet.
A fuse in your home . Replace the fuse or reset the circuit breaker.
may be blown or the
circuit breaker tripped.
Oven controls improperly set. . See the Using the clock end timer section.
Oven will not self-cleon Surface burner is on. • Turn all surface burners off.
The oven temperature is • Allow the range to cool and reset the controls.
too high to set o self-clean
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
The probe is plugged into . Remove the probe from the oven.
the outlet in the oven.
',',Crackling" or This is the sound of the . This is normal.
popping" sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. . Touch the CLEAR/OFFpad. Open the windows to
during a cleon cycle rid the room of smoke. Wait until the LOCKEDlight
goes off. Wipe up the excess soil and reset the
clean cycle.
Oven door will not Oven too hot. . Allow the oven to cool below locking temperature.
open after a clean cycle
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning oven section.
__ Oven was heavily soiled. . Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
"LOCKED" flashes The self-clean cycle has been . Close the oven door.
in the display selected but the door is not
closed.
"LOCKED" light is The oven door is locked . Touch the CLEAR/OFFpad. Allow the oven to cool.
on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
GEAppliances.com
'!F--!, and a number
or letter ash
in the display
You hove a function error code.. Touch the CLEAR/OFFpad. Put the oven back into
operation.
If the function code repeats. . Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
35