GE P2S975 Installation Instructions Manual

sta ati
str
[]
ct|
Self-Cleaning
ange
u Fu
P2S975
in Canada, call 1.800.561.3344 or Visit our Website at: www.GEAppliances.ca J
iN THE COMMONWEALTH OF
MASSACHUSETTS:
• This product must be installed by
a licensed plumber or gas fitter.
When using ball-type gas shut-off valves,
they shall be the T-handle type.
A flexible gas connector, when used,
must not exceed 3 feet.
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
• IMPORTANT - Save t hese
instructions for local inspector's use.
• IMPORTANT - Observe all
governing codes and ordinances.
Note to Installer- Be sure to leave these
instructions with the Consumer.
• Note to Consumer- Keep these
instructions for future reference.
,, Product failure due to improper installation
is not covered under the Warranty.
-4, W ARNING - This
appliance
must
be properly grounded.
Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
-&WARNING - Before
beginning
the installation, switch power off at service
panel and lock the service disconnecting means
to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten
a prominent warning device, such as a tag,
to the service panel.
31-10641-3
03-09 JR
Printed in the United States
FOR YOUR SAFETY
• All ranges can tip.
• BURNS or other SERIOUS
INJURIES can result.
• INSTALL end CHECK the
ANTI-TIP bracket following
the instructions supplied
with the bracket.
Anti-Tip Bracket
Kit Included
If you did not receive an anti-tip bracket with your
purchase, call 1.800.626.8774 to receive one at no cost.
(In Canada, call 1.800.561.3344.)
For installation instructions of the bracket, visit:
GEAppliances.com. (In Canada, www.GEAppliances.ca.)
PARTS INCLUDED
_ //_Rea r Filler
2 Screws
Screws
MATERIALS YOU MAY NEED
Joint Sealant Shut Off Valve
Lag Bolts Anchor Sleeves
(For Concrete Floors Only)
CSA-Approved Flexible Gas Line
3/8" Min. ID, 1/2" NPT Connection,
3-foot Maximum Length (Massachusetts only)
Pipe Fittings
TOOLS YOU WiLL NEED
1/4" Nut Driver _ Level _ Pipe Wrench
Tape Measure _ Drill _ Safety Glasses
Phillips Head _ Flat Head _ Wrench or Pliers
Screwdriver Screwdriver (for 1 7/16" Nut)