Lift-Off Door; Painted Surfaces - GE P2S975 Owner's Manual

GEAppliances.com
Cleaning the Oven Door
To clean the inside of the door'.
Do not let water drip into the vent openings.
i Because the area inside the gasket is
cleaned during the self-clean cycle, you do
not need to clean this by hand.
If any stain on the door vent trim is
persistent, use a soft abrasive cleaner and a
sponge-scrubber for best results,
Do not rub or clean the door gasket-
it has an extremelylow resistanceto
abrasion.
#you notice the gasket becomingworn,
frayed or damaged in any way or if it
has becomedisplaced on the door, you
should have it replaced.
iiiiiiiiii The area outside the gasket and
the door liner can be cleaned with a
soap-filled or plastic scouring pad,
hot water and detergent. Rinsewell with a
vinegar and water solution.
To clean the outside of the door'.
Use soap and water to thoroughly clean the
top, sides and front of the oven door. Rinse
well. You may also use a glass cleaner to
clean the glass on the outside of the door.
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing
acids may cause discoloration and should be
wiped up immediately. When surface is cool,
clean and rinse.
Do not use oven cleaners, cleaning powders
or harsh abrasives on the
outside of the door.
Slot
Pull hinge locks down to unlock.
Removal position
Lift-Off Oven Door
The door is very heavy. Be careful when
removing and lifting the door.
Do not liftthe door by the handle.
To remove the door'.
[Z] Fullyopen the door.
[] Pullthe hinge locks down toward the door
frame, to the unlocked position. A tool,
such as a small
flat-blade screwdriver, may be required.
r31 Firmlygrasp both sides of the door at the
top.
[] Close door to the door removal position,
which is halfway between the broil stop
position and fully closed.
rs] Lift door up and out until the hinge arm is
clear of the slot.
To replace the door'.
ry] Firmlygrasp both sides of the door at the
top.
@
%
@
With the door at Bottom
the same angle edge
of
slot
as the removal
X
position, seat the
indentation of the hinge
arm
into the bottom edge of
the hinge slot. The notch
in the hinge arm must be fully seated into
the bottom of the slot.
e arm
Fully open the door. If the door will not
fully open, the indentation is not seated
correctly in the bottom edge of the slot.
Pushthe hinge locks up against the front
frame of the oven cavity to the locked
position.
Hinge
arm
Hinge lock 0
Push hinge locks up to lock.
Closethe oven door.
Painted Surfaces
Painted surfaces include the top and sides
of the door, top of the control panel and the
drawer front. Cleanthese with soap and water or
a vinegar and water solution.
Do not use commercial oven cleaners, cleaning
powders, steel wool or harsh abrasives on any
painted surface.
31