GE P2S975 Owner's Manual page 30

Care and cleaning of the range.
_ G6.35 Bulb
I
Glass cover
Dn some moael£
Socket
ReceDl.acle
_G9
BUtD
/
Glass cover
(on some models)
Oven Light Replacement (on some models)
A WARNING: SHOCK OR BURN
HAZARD: Before replacing oven light bulb,
disconnect the electrical power to the
range at the main fuse or circuit breaker
panel. Failure to do so may result in
electric shock or burn.
A CAUTION: BURN HAZARD: The
glass cover and bulb should be removed
when cool. Touching hot glass with bare
hands or a damp cloth can cause burns.
To remove:
%
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear
the grooves of the socket. Wearing latex
gloves may offer a better grip.
[] Using gloves or a dry cloth, remove the
bulb by pulling it straight out.
To replace:
Use a new 120/130-volt halogen bulb, not
F-f] to exceed 50 watts. Replacethe bulb with
the same type of bulb that was removed.
Your model will have one of the two types
shown on the left. To determine the
correct replacement bulb, check the bulb
terminals. Bulbswith 2 straight pin
terminals are G6.35 bulbs. Bulbswith 2
looped terminals are G9 bulbs. (Do not
interchange.) Be sure the replacement
bulb is rated 120 volts or 130 volts (NOT12
volts).
r21
Using gloves or a dry cloth, remove the
bulb from its packaging. Do not touch the
bulb with bare fingers. Oil from skin will
damage the bulb and shorten its life.
loves or
r_ Pushthe bulb straight into the receptacle
all the way.
r_ Placethe tabs of the glass cover into the
grooves of the socket.Turn the glass cover
clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
[] Reconnect electrical power to the range.
_!/: i i_i:i i ki_il i iii
Wire cover holder
Oven Light Replacement (on some models)
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
r_ Hold a hand under the cover so it doesn't
fall when released. With fingers of the
same hand, firmly push back the wire
cover holder. Lift off the cover.
To replace the coven
_1 Place it into groove of the light receptacle.
Pull wire forward to the center of the
cover until it snaps into place.
Connect electrical power to the range.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt appliance
bulb.
30