Dump Control Pin - Craftsman 486.24847 Owner's Manual

STEP 18 - INSTALL DUMP CONTROL PIN STEP 19 - INSTALL HOSE CLIP AND SPACER
Install a small 1/2" washer and then the compression
spring onto the dump control pin. Install the dump
control pin into the pin stop bracket. Make sure the flat
side of the pin faces to the front when finished. See
figure 16.
Connect the hooked end of the dump cable into the
hole in the dump control pin. Install the threaded cable
adjuster down into the notch in the pin stop bracket,
placing a nut on each side of the notch. Adjust and
tighten the adjuster nuts so that the tapered end of the
dump control pin extends 3/4" through the side of the
pin stop bracket. See figure 16.
DUMP CONTROL PIN
3/4"--,.-__
PIN STOP
BRACKET
I
DUMP CONTROL PIN
PIN
BRACKET
Secure the dump cable to the back of the bucket using
a hose clip, #10 x 5/8" truss-head bolt and #10-32
nylock nut. See figure 17.
Store the unused 3/8" spacer from step 7 on the lift
frame using a 5/16" x 1" hex bolt and nylock nut. See
figure 17.
3/8" SPACER
5/15"x 1 "
REX
BOLT_ /. I I
5/16"
I/
NYLOCK
IJl NUT
#10-32 NYLOCK NUT
/
FIGURE 17
#10 x 5/8"
HOSE TRUSS
CLIP HEAD BOLT
STEP 20 - INSTALL (LT) SIDE PLATES
Install a large 1/2" washer and a 1/2" spacer onto a
1/2" x 1-1/2" hex bolt. Install the bolt into the hole
shown in the left (LT) side plate, and fasten using a
nylock nut. Repeat the step for the right side plate, but
install the bolt, flat washer and spacer from the
opposite direction. See figure 18.
FIGURE 16
1/2" NYLOCK
NUT
LEFT (LT)
SIDE PLATE
\
USE THIS HOLE /
/
1/2" SPACER
LARGE 1/2"
WASHER
1/2" x 1-1/2"
"-.,_ _HEXBOLT.
FIGURE 18
12