Finding An Entry In The Dialing Translation Table - Nortel Voice Mail 4.0 FAX Set Up And Operation Manual

64 Appendix B: Dialing Translation

Finding an entry in the Dialing Translation Table

For convenience, the System Coordinator can locate a specific entry in the Dialing
Translation Table. The Input value must be entered in order to find the entry.
To find a specific entry in the Dialing Translation Table:
Log:
QUIT RETRY
Admin
MBOX AA
Dialing
PARM
Dial table
ADD
inval* outval*
NEXT
inval* outval*
CHNG DEL
In:
RETRY
inval* outval*
NEXT
FAX Set Up and Operation Guide
ƒ · ° ‹
1. Press
2. Enter the System Coordinator Mailbox number and
password and press OK.
° °
3. Press
OTHR
4. Press TABLE. If Centrex is installed on your Norstar
QUIT
system, QUIT is replaced by NEXT.
5. Press CHNG.
QUIT
6. Press OTHR.
inval* outval* is an example of a Table entry.
7. Press FIND.
8. Enter the Input value of the entry you wish to find
OK
and press OK.
9. Repeat steps 6 through 8 to find other entries in the
Dialing Translation Table.
Note: The inval* outval* is an example of a
Table entry. The * character shown after a
value signifies any digits in the telephone
number remaining to be dialed. Norstar Voice
Mail automatically adds the * character after
every Input and Output value.
®
10. Press
.
.
to end this programming session.
P0886629 Issue 1.0