Deleting A Dialing Translation Table Entry - Nortel Voice Mail 4.0 FAX Set Up And Operation Manual

66 Appendix B: Dialing Translation

Deleting a Dialing Translation Table entry

The System Coordinator can delete an entry in the Dialing Translation Table at any
time. To locate the entry that you wish to delete, refer to
the Dialing Translation Table"
Translation Table"
To delete an entry in the Dialing Translation Table:
Log:
QUIT RETRY
Admin
MBOX AA
Dialing
PARM
Dial table
ADD
inval* outval*
NEXT
inval* outval*
CHNG FIND
Deleted
inval2* outval2*
NEXT
FAX Set Up and Operation Guide
on page 63 or
on page 64.
ƒ · ° ‹
1. Press
2. Enter the System Coordinator Mailbox number and
password and press OK.
° °
3. Press
OTHR
4. Press TABLE. If Centrex is installed on your Norstar
QUIT
system, QUIT is replaced by NEXT.
5. Press CHNG.
QUIT
6. Press OTHR. The inval* outval* is an example
of a Table entry. The * character shown after a
value signifies any digits in the telephone number
remaining to be dialed. Norstar Voice Mail
automatically adds the * character after every Input
and Output value
7. Press DEL.
8. This transient display shows Deleted and then the
display changes to show the next entry in the table:
9. Repeat steps 6 through 8 for every entry you want to
delete.
The inval2* outval2* is an example of the next
Dialing Translation Table entry.
®
10. Press
"Reviewing the entries in
"Finding an entry in the Dialing
.
.
to end this programming session.
P0886629 Issue 1.0