Appendix A: Fax Programming Record; Before You Begin; Programming Overview - Nortel Voice Mail 4.0 FAX Set Up And Operation Manual

Appendix A: FAX Programming Record

Before you begin

• Make copies of the pages in this chapter you will need for recording more
program settings.
• When a telephone is used for programming, a Norstar two-line telephone must
be used.

Programming overview

This overview provides a recommended approach to FAX programming. To use
this overview:
• Start at the top and progress down through the programming options. Determine
which options require your attention.
• You will be programming Fax Mail on an installed Norstar Voice Mail system.
Refer to the Norstar Voice Mail documentation for information on Norstar
Voice Mail system operation. Refer to the Norstar Voice Mail Programming
Record for specific information about what has already been programmed for
Norstar Voice Mail.
• Refer to the page number to find where that option is in this Programming
Record. Space is provided for you to write the option or circle an option (if
provided). The defaults are shown in bold text.
• Instructions for accessing each programmable option are provided in brackets
("F" means "Feature").
Note: To record the programming for the Dialing Translation Table, refer to
the Norstar Voice Mail Programming Record.
.
Description of programming
Record a general description of your fax setup
Record dialing translation parameters for your system
Add Fax Mailboxes
(F983, then press MBOX and follow prompts)
Configure Fax Mailboxes
(F983, then press FAX and follow prompts)
Define Fax System Group Lists
(F983, then press GLIST and follow prompts)
P0886629 Issue 1.0
Title Page
Pre-installation page 52
checklist
Dialing Translation page 52
Parameters
Mailbox page 53
Administration
Mailbox page 56
Configuration
Fax System Group page 55
Lists
FAX Set Up and Operation Guide