Changing An Entry In The Dialing Translation Table - Nortel Voice Mail 4.0 FAX Set Up And Operation Manual

Changing an entry in the Dialing Translation Table

After a Dialing Translation Table has been built, you can change the Output value
of an entry at any time. To locate the entry that you wish to change, refer to
"Reviewing the entries in the Dialing Translation Table"
entry in the Dialing Translation Table"
Note: You cannot change the Input value of an entry. The entry must be deleted
and a new entry must be created with new Input and Output values. Refer to
"Deleting a Dialing Translation Table entry"
To change an entry in the Dialing Translation Table:
Log:
QUIT RETRY
Admin
MBOX AA
Dialing
PARM
Dial table
ADD
inval* outval*
NEXT
inval* outval*
DEL FIND
Out:
RETRY
inval* outval*
NEXT OTHR
P0886629 Issue 1.0
ƒ · ° ‹
1. Press
2. Enter the System Coordinator Mailbox number and
password and press OK.
° °
3. Press
OTHR
4. Press TABLE. If Centrex is installed on your Norstar
QUIT
system, QUIT is replaced by NEXT.
5. Press CHNG.
QUIT
6. Press OTHR. inval* outval* is an example of a
Table entry. The * character shown after a value
signifies any digits in the telephone number
remaining to be dialed. Norstar Voice Mail
automatically adds the * character after every Input
and Output value.
7. Press CHNG.
8. Enter the new Output value and press OK.
9. Repeat steps 6 through 8 to change any other entries
in the Dialing Translation Table.
®
10. Press
Appendix B: Dialing Translation 65
on page 63 or
on page 64.
on page 66.
.
.
to end this programming session.
FAX Set Up and Operation Guide
"Finding an