Reviewing The Entries In The Dialing Translation Table - Nortel Voice Mail 4.0 FAX Set Up And Operation Manual

Reviewing the entries in the Dialing Translation Table

You can review or check the entries in your Dialing Translation Table at anytime.
To review your Dialing Translation Table entries:
Log:
QUIT RETRY
Admin
MBOX AA
Dialing
PARM
Dial table
ADD
inval* outval*
inval* outval*
P0886629 Issue 1.0
ƒ · ° ‹
1. Press
2. Enter the System Coordinator Mailbox number and
password and press OK.
° °
3. Press
OTHR
4. Press TABLE. If Centrex is installed on your Norstar
QUIT
system, QUIT is replaced by NEXT.
5. Press CHNG.
QUIT
6. Press NEXT to view the next entry in the Dialing
OTHR
Translation Table.
Note: The display shows 16 characters. If the total
number of Input and Output values equals
more than 16 digits a VIEW> softkey will
appear on the left side of the display. After
you have pressed VIEW> to view the digits
furthest to the right, the softkey changes to
<VIEW. Press the <VIEW softkey to view the
digits on the left again. The inval*
outval* is an example of a Table entry.
The * character shown after a value
signifies any digits in the telephone number
remaining to be dialed. Norstar Voice Mail
automatically adds the * character after
every Input and Output value.
7. Continue pressing NEXT to view all the entries in
OTHR
the Dialing Translation Table.
®
8. Press
Appendix B: Dialing Translation 63
.
.
to end this programming session.
FAX Set Up and Operation Guide