Assembling Micro Adjust And Racks - Craftsman Contractor 113.299112 Owner's Manual

18,Align thefence's p lastic endcaptomatch t heprofile
of the head.Install2 self tap 10-32pan head
screws intotheholes.
NOTE:Adjust c apso it doesnot interfere withfront
guidebar, The screwsare self tapping.Drivethe
screws i n until c apisseated against thefence head.
ASSEMBUNG MICRO ADJUST AND
RACKS
1. From among the loose parts find the following hard-
ware:
10 Pan Head Screw - 10-32 x 3/8" long
10 Square Nuts - 10-32
8 Plain Washers - 13/64"
10 Lockwashers - 3/16" 1. Diam.
1 Micro Adjust Assembly
2 Racks
10-32 X 3/8"
©
3/16"
LOCKWASHER
13/64"
PLAIN
WASHER
! 0-32
S<:_. NUT
2. Take rack with teeth facing down and insert 4 pan
head screws 10-32 x 3/8" with 3/16" Iockwasher and
13/64" plain washer in the 4 holes. Install from the
underside. Install four 10-32 square nuts on the top
side of the rack onto the pan head screws. Turn the
nuts until there is a 1/8"+ space between the inside
of the nut & the top of the rack. Slide the nuts with
the rack attached from the left end into the middle
slot, until the end of the rack is 5-1/2" past the left
end of the front guide bar, Tighten all screws.
10-32
SQ. NUTS
\
MICRO ADJUST
ASSEMBLY
RACK
13/64" pLAIN WASHER
3/16 '=
LOCKWASHER
29