Degree Position - Craftsman Contractor 113.299112 Owner's Manual

tf b_ade i s NOTSQUARE t otabIe.,,the 9 0degree s top
screw must b eADJUSTED
A. Unscrew 90 degree STOP SCREW three to four
_ums usil_g 3/16 tn HEX L" wrench.
B -rum tilt handwheet ciockwise one turn taen turn
handwnee_ counterc½ockwise u_tit blade _s square
w_tt_table
C Screw 90 degree stop screw IN until it
stops...check once again for squareness and
react!ust screw, if necessary.
/
/
/
/
/
/
45 ° POSITION
TILT blade to LEFT as far as _twilt go.
A. Place an ACCURATE square against blade.
Make sure square is not touching the TIP of one
of the saw TEETH,
If blade is 45 degrees to table;
A. Check pomter,
If POINTER DOES NOT point to the 45 degree mark
on thescale;
A, Remove Elevation Handwheel.
B. Loosen two screws on scale and adjust scale until
POINTER points to 45 degree mark
C. Install Elevation Handwheel.
SCALE
tf blade is NOT 45 ° TO TABLE_,STOP SCREW and
SCALE must be ADJUSTED.
1. Unscrew 45 degree STOP SCREW three to four
turns using 3/16 in. setscrew wrench.
2. Turn tilt handwheel until blade is 45 degrees to the
table.
3. Screw 45 degree stop screw tN until it stops...check
once again and readjust screw, if necessary.
/
/
/
45°
STOPSCREW
60