Craftsman Contractor 113.299112 Owner's Manual page 17

mNSTA.LLING TABLE SAW DUST
COLLECTOR
1. From among the loose parts, find the following hard-
ware:
2 Hex Head Screw 1/4-20 x 5/8
2 Hex Nuts 1/'4-20
2 Lockwasher, t/4 External Type
2, Look underneath the saw to locate the proper posi-
tion for the chute. With the discharge opening facing
the rear of the saw; slip the front and rear notches of
the chute's right hand side on top of the Adapter
Plates. Compress the left hand side slightly to allow
easy passage on top of the left hand side of the
adapter plates; release the side pressure while posi-
tioning the left hand housing notch over the adapter
plates.
LEFT
FRONT
NOTCH
RIGHT RIGHT
REAR FRONT
NOTCH _ NOTCH
DISCHARGE NOZZLE
TOWARD REAR
3. Slide the door up and under upper tabs on the open
face of the chute. Push the bottom edge of the door
towards the rear of the saw to snap it over lower tab
of chute.
UPPER
LOWER _
TABS
DOOR
17