Push Stick And Push Block; Auxiliary Fence/Work Support - Craftsman Contractor 113.299112 Owner's Manual

WORK FEEDDKV{CKS (cor_tinued)
Making the hand!e:
o ply",tvooc_ t o shape and
,,I _ piece _''
C ....... o_'o8 ir_ch thick n, , _
" _ SIqOWR:
NOTE: The mitered corners ea_sbe any s_=ze that looks
3/4" PLYWOOD
o Position! the hande in the cef_ter of tf-_e #tywood
base. Fasten them together with glL_e and wood
screws.
_MPORTANT: Make sure, the screw heads do not stick
out from ti-_ebosom of the base, they must be flush or
recessed. The bottom must be fiat and smooth enough
to s_ide along the au×iiiarv fence you are now ready to
make
3/8" PLYWOOD
,Jo
PUSH BLOCK
i --
Auxiliary Fence
Making the base:
- Start with a piece of 3/8 inch plywood at Jeast 5-1/2
inches wide or wider and 30 inches long or longer.
o Cut the piece to shape and size shown:
Making the side:
o Start with a piece of 3/4 inch plywood at least 2-3/8
inches wide or wider and 27 inches long or longer.
, Cut the piece to shape and size shown:
Putting it together
- Put the pieces together, as shown:
IMPORTANT: Make sure the screw heads do not sticl<
out from the bottom of the base, they must be flush or
recessed. The bottom must be flat and smooth enough
to rest on the saw table without rocking.
3_ N
3/8" THICK PLYWOOD
BASE
27"
314" THICK PLYWOOD
SIDE
l_
4-1_"
3/4" PLYWOOD _ • ,,
3/8" / //
PL._40OD _
_
THIS F ACE AHD
THIS EDGE MUST ._
BE PARALLEL--I"
AUXiLiARY FENCE
43