Hitachi XP P9500 User Manual page 89

>dlnkmgr offline -cha -pathid 000001
KAPL01055-I All the paths which pass the specified CHA port
will be changed to the Offline(C) status. Is this OK? [y/n]:y
KAPL01056-I If you are sure that there would be no problem
when all the paths which pass the specified CHA are placed in
the Offline(C) status, enter y.
KAPL01061-I 2 path(s) were successfully placed Offline(C); 0
path(s) were not. Operation name = offline
>
-pathid AutoPATH_ID
Use this parameter to place a single path offline.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
(Displays Information) on page
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the offline operation.
-hbaportwwn HBA-port-WWN
Use this parameter to place offline all the paths connected to an HBA port
associated with a specific HBA port WWN. Only one set of values can be
specified for the -hbaportwwn parameter.
For HBA-port-WWN, specify the value of HBAPortWWN. The parameter is
not case sensitive.
To display HBAPortWWN and PathName, execute the view operation as
follows:
>dlnkmgr view -path -hbaportwwn
For details on how to execute the view operation and display the HBA
port WWN and path name, see
in Parameters (To display program information) on page
Example
The following shows an example of placing offline the paths for which
the HBA port WWN is 10000000C93213BA while confirming command
operation.
>dlnkmgr offline -path –hbaportwwn 10000000C93213BA
KAPL01052-I The currently selected paths will be changed to
the Offline(C) status. Is this OK? [y/n]: y
KAPL01053-I If you are sure that there would be no problem
when the path is placed in the Offline(C) status, enter y.
Otherwise, enter n. [y/n]: y
KAPL01061-I 1 path(s) were successfully placed Offline(C); 0
path(s) were not. Operation name = offline
Hitachi Dynamic Link Manager User Guide (for VMware(R))
6-22. Leading zeros can be omitted
To display path information on page 6-29
Command Reference
Otherwise, enter n. [y/n]:
6-24.
view
6-9