Hitachi XP P9500 User Manual page 111

When you specify the -path parameter together with the -item
parameter, the command only displays the items specified by the value of
the -item parameter.
When the value of the -item parameter is omitted, only the PathID and
the Status fields are displayed.
Table 6-8 Correspondence between the items displayed by the dlnkmgr
view -path -item command and the values of the -item parameter on
page 6-31 shows the correspondence between the items that can be
displayed by the dlnkmgr view -path -item command and the parameter
values for displaying each item.
Table 6-8 Correspondence between the items displayed by the dlnkmgr
view -path -item command and the values of the -item parameter
Items displayed by the dlnkmgr view
-path -item command
#
PathID
PathName
HBAPortWWN
DskName
iLU
ChaPort
#
Status
Type
IO-Count
IO-Errors
DNum
HDevName
IEP
VmRuntimeName
VmState
VmPathUID
#
Because both PathID and Status are always displayed, you do not
have to specify any parameters.
In the sub-parameters following -path -item, you can list the paths
(-hdev) and sort the list (-srt). If you omit both parameters, the
command displays information for all the paths in ascending order of
AutoPATH_IDs.
These sub-parameters are:
Command Reference
Hitachi Dynamic Link Manager User Guide (for VMware(R))
Values specified after the -item
parameter
None
pn
hbaportwwn
dn
lu
cp
None
type
ic
ie
dnu
hd
iep
vmruntimename
vmstate
vmpathuid
6-31