Brocade 7500 / FR4-18i and Brocade MIBs
Beginning with release Fabric OS 5.3.0, statistics are available for FCIP tunnels, VEX_Ports, or
VE_Ports through the portstatsshow command.
The changes in the sensor details for FR4-18i Blade has been incorporated into SNMP. The
"connUnitSensorTable 1.3.6.1.3.94.1.8"
1.3.6.1.4.1.1588.2.1.1.1.1.22"
sensorShow command.
Access Gateway and Brocade MIBs
Brocade Access Gateway supports the following MIBs.
TABLE 3
MIB Name
MIB-2
Entity-MIB
HA MIB
SW-MIB
FA-MIB
FE-MIB
CPQ-Rack MIB
FCIP MIB
iSCSI MIB
Firmware Upgrades and Enabled Traps
Prior to Fabric OS v4.4, traps were turned on and off as a group (for example, the SW-Trap, or
FA-Trap). In these versions of the Fabric OS it was not possible to set individual traps (such as,
swSensorStatusChangeTrap, swTrackChangesTrap, or connUnitEventTrap).
In Fabric OS v4.4 or above you can to turn on and off traps individually within a trap group. After the
trap group is enabled, the individual traps need to be enabled explicitly.
Because the pre- Fabric OS v4.4 firmware only has trap group level settings, when you upgrade to
the Fabric OS v4.4 firmware or above, individual traps are turned off by default even if the
corresponding trap group was enabled before upgrading. When moving from a downlevel version to
Fabric OS v4.4 or above you must use the snmpconfig command to turn on explicitly the individual
traps within each trap group.
Fabric OS MIB Reference
53-1001156-01
on page 552 display information consistent with the Fabric OS
Access Gateway MIB Support
Supported
Yes
Yes
Yes
No
Yes
No
Limited
Limited
Limited
Brocade 7500 / FR4-18i and Brocade MIBs
on page 920 and
"swSensorTable
Description
Updated to support Access Gateway in v5.2.1.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
The connUnitSnsTable is not supported because a switch in Access
Gateway does support name server services.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
Supported on embedded switches only.
Implemented to support WAN interfaces in Fabric OS v5.3.0
Supports displaying information about virtual targets (VTs), iSCSI
sessions, and TCP connection tables, as derived from specific MIB
tables
1
11