Fibre Channel Port Group - Brocade Communications Systems StoreFabric SN6500B Reference Manual

6

Fibre Channel port group

TABLE 49
Object and OID
swAgtTrapRcp
1.3.6.1.4.1.1588.2.1.1.1
.4.11.1.3
swAgtTrapSeverityLevel
1.3.6.1.4.1.1588.2.1.1.1
.4.11.1.4
Fibre Channel port group
This group contains information about the physical state, operational status, performance, and
error statistics of each Fibre Channel port on the switch. A Fibre Channel port is one which
supports the Fibre Channel protocol, such as F_Port, E_Port, U_Port, or FL_Port.
TABLE 50
Object and OID
swFCport
1.3.6.1.4.1.1588.2.1.1.1.6
swFCPortCapacity
1.3.6.1.4.1.1588.2.1.1.1.6.1
swFCPortTable
1.3.6.1.4.1.1588.2.1.1.1.6.2
swFCPortEntry
1.3.6.1.4.1.1588.2.1.1.1.6.2
.1
swFCPortIndex
1.3.6.1.4.1.1588.2.1.1.1.6.2
.1.1
152
Access Description
Read-write This is the trap recipient associated with the community. If a new value
is set successfully, it takes effect immediately.
If not otherwise set, the default IP address for this trap recipient is
0.0.0.0 and the SNMP trap is not sent for the associated community
string.
With a setting of non-0.0.0.0 IP address, SNMP traps are sent to the
host with the associated community string.
Any or all of the trap recipients can be configured to send a trap for the
associated community string. The maximum number of trap recipients
that can be configured is six. If no trap recipient is configured, no traps
are sent.
The trap recipient IP address should be part of the Access Control List
for Fabric OS v2.6.1, v3.1, and v4.x (refer to the Fabric OS Command
Reference and the snmpConfig command for more information).
Read-write This is the trap severity level associated with "swAgtTrapRcp".
The trap severity level, is in conjunction with the event's severity level.
When an event occurs, and if its severity level is at or below the set
value, the SNMP trap is sent to configure trap recipients. The severity
level is limited to particular events. If a new value is set successfully, it
takes effect immediately.
This object obsoletes "swEventTrapLevel".
Access Description
Not The OID sub-tree for Fibre Channel port group.
accessible
Read only The maximum number of Fibre Channel ports on this switch. It
includes G_Port, F_Port, FL_Port and any other types of Fibre Channel
port.
Not A table that contains one entry for each switch port, configuration and
accessible service parameters of the port.
Not An entry containing the configuration and service parameters of the
accessible switch port.
Read only The switch port index.
The value of swFCPortIndex is 1 higher than the actual port index. For
example, a swFCPortIndex of 1 corresponds to the actual port index of
0.
Fabric OS MIB Reference
53-1002750-01