Brocade Communications Systems StoreFabric SN6500B Reference Manual page 98

4
fcFeConfig group
TABLE 27
Object and OID
fcFeFabricName
1.3.6.1.2.1.75.1.1.1
fcFeElementName
1.3.6.1.2.1.75.1.1.2
fcFeModuleCapacity
1.3.6.1.2.1.75.1.1.3
fcFeModuleTable
1.3.6.1.2.1.75.1.1.4
fcFeModuleEntry
1.3.6.1.2.1.75.1.1.4.1
fcFeModuleIndex
1.3.6.1.2.1.75.1.1.4.1.1
fcFeModuleDescr
1.3.6.1.2.1.75.1.1.4.1.2
fcFeModuleObjectID
1.3.6.1.2.1.75.1.1.4.1.3
fcFeModuleOperStatus
1.3.6.1.2.1.75.1.1.4.1.4
fcFeModuleLastChange
1.3.6.1.2.1.75.1.1.4.1.5
78
Access Description
Read-write The Name_Identifier of the fabric to which this fabric element
belongs.
This object returns the WWN of the primary switch in the fabric.
Read-write The Name_Identifier of the fabric element.
This object returns the WWN of the switch.
Read only The maximum number of modules in the fabric element, regardless
of their current state.
The valid value for all Brocade switches is 1.
Not accessible A table that contains information about the modules, one entry for
each module in the fabric element.
Not accessible An entry containing the configuration parameters of a module.
Not accessible Identifies the module within the fabric element for which this entry
contains information. This value is never greater than
fcFeModuleCapacity. This entry never shows any value as it is shown
as non accessible in the browser.
Read only A textual description of the module. This value should include the full
name and version identification of the module. It should contain
printable ASCII characters.
Refer to "sysDescr"
Read only The vendor's authoritative identification of the module. This value
might be allocated within the SMI enterprises subtree (1.3.6.1.4.1)
and provides a straightforward and unambiguous means for
determining what kind of module is being managed.
For example, this object could take the value 1.3.6.1.4.1.99649.3.9
if vendor "Neufe Inc." was assigned the subtree 1.3.6.1.4.1.99649
and had assigned the identifier 1.3.6.1.4.1.99649.3.9 to its
"FeFiFo-16 PlugInCard."
Refer to "sysObjectID"
Read only Indicates the operational status of the module.
Valid values:
•
1 - online, module functioning properly
•
2 - offline, module not available
•
3 - testing, module in test mode
•
4 - faulty, module is defective
Read only Contains the value of sysUpTime when the module entered its
current operational status. A value of 0 indicates that the
operational status of the module has not changed since the agent
last restarted.
on page 33.
on page 33.
Fabric OS MIB Reference
53-1002750-01