Carriage Motor / Timing Belt Removal - Epson 610 Service Manual

EPSON Perfection 610

4.2.6 Carriage Motor / Timing Belt Removal

1. Release the Carriage Lock. (See Section 4.2.1.)
2. Remove the Document Cover. (See Section 4.2.2.)
3. Remove the Upper Housing. (See Section 4.2.3.)
4. Remove the Carriage Unit. (See Section 4.2.5.)
5. Remove the two screws (CBS, M3x4) securing the FFC fixing plate,
and then remove the FFC fixing plate.
6. Remove the three screws (gold, CBS, M3x4/M3x6) and the two
hooks at the rear edge, and then remove the main board cover.
7. Remove the two screws (gold, CBS, M3x4) securing the CR Motor
Unit, and then shift the CR Motor Unit inward.
8. Disconnect the cable for the CR Motor Unit from the connector on
the main board, and then remove the CR Motor Unit.
6. CBS Screws M3x6)
6. Main Board Cover
6. CBS Screw (M3x4)
Figure 4-21. Shield Plate Removal
Assembly and Disassembly
6. Hooks
5. FFC Fixing Plate
5. CBS Screws (M3x4)
Disassembly Procedures
Connector
CBS Screws (M3x4)
Figure 4-22. CR Motor Unit Removal (1)
Figure 4-23. CR Motor Unit Removal (2)
Revision B
CR Motor Unit
36