Setting The Dhcp Server - Sharp Notevision PG-M25X Operation Manual

Setting the DHCP
This function is set when using the DHCP
server on the projector.
Set "DHCP Server" in the network menu
on the menu screen.
➝ For operating the menu screen, see
pages 50 to 55.
Note
• "Start Address" and "Max Lease" can be
set when DHCP server function is set to
"OFF".
• If a password has been set, the password
input box will be displayed when selecting
"DHCP Server".
⁄ Disabling the DHCP server function
Set the "Server" in the submenu to "OFF".
¤
Setting the Assign "Start Address"
Set the Assign Start Address in Start
Address in the Submenu.
For setting the start address, see the pro-
cedure in Setting the TCP/IP
‹
Assigning a maximum number of
IP addresses
This function is for setting the maximum
number of IP addresses from the start
address that can be automatically
assigned.
Make sure to set an approximate
amount of the computers that are to
be connected to the wireless LAN.
You can set anywhere between 1 to
253 computers.
Note
• IP addresses will not be assigned if the
last three digits of their number are more
than 255.
›
Enabling the DHCP server function.
Set "Server" in the submenu to "ON".
Note
• When the DHCP server function is set to
"ON", restart your computer.
• When the DHCP server function of the
projector has been set in a wireless LAN
where there is another DHCP server
(including the projector) connected, the
network may not function correctly. If there
is another DHCP server connected, make
sure to consult with your Network
Administrator.
Server
(page 70).
Select "Yes"
-73