Sharp Notevision PG-M25X Operation Manual page 39

4
Press and select the input
mode.
• Each press switches in the following
order:
→ INPUT 1 → INPUT 2 → INPUT 3 → INPUT 4
• You can also use the
GyroRemote.
Note
• When no signal is received, "NO SIG-
NAL" will be displayed. When a signal
that the projector is not preset to
receive is input, "NOT REG." will be
displayed.
• When Auto Search is ON, the input
modes with signals can be selected
(See page 90.)
• When a PC card is inserted, the input
will automatically change to INPUT 4.
• You can select the input mode directly
by using the Button Assign function
on the GyroRemote (See
About the INPUT Modes
INPUT 1 Used for projecting images
(RGB/ from equipment that sends
Component) RGB signals or Component
signals connected to the DVI-
DIGITAL/ANALOG input port.
INPUT 2 Used for projecting images
(S-Video) from equipment connected to
the S-VIDEO input terminal.
INPUT 3 Used for projecting images
(V ideo ) from equipment connected to
the VIDEO input terminal.
INPUT 4 When projecting from a wire-
(PC Card) less LAN PC card or a
memory card.
• Transmission will be stopped if the input
is switched when a wireless LAN PC
card is installed in INPUT 4 and the
projector is connected to a computer.
5
Press or
to adjust the volume.
Note
• Pressing "+" will raise the volume.
Pressing "–" will lower the volume.
• On the GyroRemote, the volume can
be adjusted by pressing
• When a PC card is installed,
on the projector or
GyroRemote operate as cursor
buttons (\, |) when the OSD menu
is active.
on the
page 41.)
on the projector
.
,
on the
"On-screen Display (Example)
INPUT 1 Mode
Using
DVI digital
Using
Analog RGB
Using
Component
INPUT 2 Mode
Using S-Video
INPUT 3 Mode
Using Video
INPUT 4 Mode
Memory card installed
-35