Using The Gyroremote; Calibrating The Gyroremote - Sharp Notevision PG-M25X Operation Manual

Using the GyroRemote

Info
•
The GyroRemote emit s operation signals
according to the angle and change of
angle of the GyroRemote.
•
You can smoothly
GyroRemote just by turning your wrist.
•
The movements of the GyroRemote send
signals to the projector while holding down
on the rear of the GyroRemote.
•
If is not held down, the movements
of the GyroRemote do not send signals
to the projector.
•
If is pressed twice, the GyroRemote
will continuously send signals to the
projector. Pressing
the GyroRemote to its normal condition.
Calibrating the
GyroRemote
If there are any extreme temperature changes
when the GyroRemote is being used or after
batteries have been replaced, the mouse
cursor or pointer may continue to move by
itself even if no action has been performed. In
this case, calibrate the GyroRemote using the
following procedure.
1
Press on the rear of the
GyroRemote twice.
2
Make sure that the LED
indicator is lit, and place the
GyroRemote on a leveled
location.
• After leaving the GyroRemote for 6
seconds, the calibration of the
GyroRemote is complete.
3
Press , after leaving the
GyroRemote for more than 6
seconds.
• Calibration is complete after the
remote has been left for more than 6
seconds.
operate the
again will return
GYRO ACTIVE
button
-19