Using The Lens Cap - Sharp ViewCam Slim VL-AX1S Operation Manual

Preparation
10
Turn the CONTROL dial to select "10 "
(hour), then press the dial.
SE T T I NG
11
Turn the CONTROL dial to select "30"
(minute), then press the dial.
• The internal clock now starts operating.
SE T T I NG
12
Press the MENU button to turn off the
menu screen.
Note:
• If the date and time have been set, the MANUAL
SET screen ( ) appears in step 3. Select
"AREA" in the CLOCK SET screen (
CONTROL dial.
Changing to the 12-hour Time
Mode
1
After performing step 11 above, turn the
CONTROL dial to select "12H/24H",
then press the dial.
C L O C K S E T
D I S P L A Y
A R E A
S UMR
S E T T I NG
1 2 H 2 4 H
R E T UR N
2
Turn the CONTROL dial to select "12H",
then press the dial.
1 H 2 4H 2
3
Press the MENU button to turn off the
menu screen.
Notes:
• The date and time, once set, are internally
recorded even when not displayed on the
screen.
• The menu screen automatically turns off if no
settings are made within five minutes.
17
2. 6 2 0 0 3 .
:
1 0 0 0
2. 6 2 0 0 3 .
:
1 0 3 0
) using the
T I ME
/ 1 2 H
2 4 H
1 2H

Using the Lens Cap

Attach the strap of the lens cap to the hand
strap as shown below.
When attaching or removing the lens cap,
grasp the indents on both sides of the cap.
When recording, remove the lens cap and
attach the lens cap cord to the fastener so that
the cap will not get in the way.
Fastener
Note:
• Always attach the lens cap over the lens when
not using the camcorder.
Indents