Editing - Sharp ViewCam Slim VL-AX1S Operation Manual

Editing

Available mode:
TAPE-VCR
Video editing lets you refine your videos by
removing unwanted sequences from your tape,
or transposing one sequence with another.
This camcorder lets you monitor the source
program on the built-in LCD monitor without
having to connect it to an external TV or video
monitor.
Connect the camcorder to a VCR with the
supplied audio/video cable, as shown.
Yellow: To video input jack
White: To audio input (L) jack
Red: To audio input (R) jack
S-video cable: To S-video input socket
Playback
(commercially available)
Audio/video cable (supplied)
To AV jack
To S-VIDEO socket
: The arrow shows the signal flow.
Notes:
• If your VCR has a 21-pin Euro-SCART connector,
use the RCA/21-pin Euro-SCART conversion
connector (QSOCZ0033TAZZ).
21-pin Euro-SCART on VCR
RCA/21-pin Euro-SCART
0
conversion connector
(QSOCZ0033TAZZ)
VIDEO AUDIO AUDIO
(L/MONO) (R)
Audio R
Video
Audio L
• See page 3 for how to open the jack cover.
• If your VCR has only one audio input jack, use the
white plug for the audio connection on the VCR.
• If your VCR has an S-video input socket, you can
connect it to the S-VIDEO socket on the camcorder
with a commercially available S-video cable.
Recording
PLAY
POWER
TV/VCR SET UP
S-video cable
Cutting Unwanted Sequences
1
Playback the tape to be edited on the
camcorder, and locate the beginning
and end of the sequence you wish to
cut. Write down the time code reading at
the beginning and end of that sequence
(see page 63). Then rewind the tape to
before the beginning of the portion that
you wish to keep.
2
Load a video cassette into the recording
VCR.
3
Press
playback, then press the Record button
on the VCR to begin recording.
CHANNEL
PAUSE
/STILL
STOP/
EJECT
REC
4
Press the Pause/Still button on the VCR
to pause recording when the source
tape reaches the beginning of the
sequence to be cut.
5
Press the Pause/Still (or Record) button
on the VCR to resume recording when
the source tape reaches the end of the
sequence to be cut.
To stop editing
Press on the camcorder and press the Stop
button on the VCR.
Notes:
• Some of the transitions between edited
sequences may be slightly off.
• There may be picture noise during video search
or still playback. This does not imply a defect in
the camcorder.
• The time code display will be recorded along
with the edited sequences if the TC OUT item is
set to "ON". Set to "OFF" before editing (see
page 63).
on the camcorder to begin
64