13
VL-PD6H/009-018
Downloaded from:
http://www.usersmanualguide.com/
Preparation
Adjusting the Hand Strap
1
Open the hand strap flap (Q) and the grip
strap (W).
Q
2
Loosen the grip strap, pass your right hand
through the loop, and put your thumb on
the REC START/STOP button and your
forefinger and middle finger on the Power
Zoom buttons. Then, pull the grip strap
tight until it fits snugly.
Power Zoom buttons
REC START/STOP button
3
Seal the velcro fasteners of the grip strap
and the hand strap flap.
Caution:
• Do not swing the camcorder by the hand strap.
Using the Lens Cap
When attaching or removing the lens cap,
press both tabs on the top and bottom of the
cap.
Tabs
13
When recording, hang
the hook of the lens
cap on the hand strap
so that the cap will not
get in the way.
W
Note:
• Always replace the lens cap on the lens when
the camcorder is not in use.
Attaching the Shoulder Strap
1
Hold one end of the strap and thread it
through the loop on the left side of the
power source connection panel.
2
Loosen the strap in the buckle, then feed
the end of the strap through the buckle, as
shown.
3
Draw the strap in the direction of the arrow
to secure.
4–6
To attach the other end of the strap to the
loop on the left side of the hand strap,
open the hand strap flap, and perform the
same procedure.
1
Loop
2
Buckle
3
Hook
4
Loop
5
Buckle
6
01.4.24, 0:24 PM